Page of 6

Peavey Session 400 Operating Manual

Single-unit steel guitar amp.
Hide thumbs

   Also See for Peavey Session 400

   Related Manuals for Peavey Session 400

   Summary of Contents for Peavey Session 400

  • Page 2

    (+ or -) or until the noise is minimized. NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT MODELS.

  • Page 3: Block Diagram

    Tone Settings Adjust to Taste Adjust to Taste Adjust to Taste Adjust to Taste Adjust to Taste Tone settings given are general and will vary according to type of guitar, type and gauges of strings, type of pickup and even type of pick. Personal taste, playing style, and type of music greatly contribute to desired tonality. BLOCK DIAGRAM PRE-EQ PRE AMP...

  • Page 4

    SESSION@ 400 LIMITED ENGINEERING SPECIFICATIONS POWER AMPLIFIER SECTION Rated Power & Load 210 Watts into 4 ohms with DDT’” compression Power @ Clipping: (typical) (5% THD, 1 kHz, 120 VAC line) 240 Watts RMS into 4 ohms Frequency Response: +O, -2 dB, 80 Hz to 10 kHz, @ 200 Watts RMS into 4 ohms Total Harmonic Distortion: Less than 0.2%, 100 mW to 200 Watts...

  • Page 5

    FOOTSWITCH JACK (21) Provided for connection of the supplied remote footswitch. Footswitch is used to defeat reverb, post effects loop 1, and post effects loop 2. Effects Device or Volume Pedal Session 400 Effects Device Effects Device Shielded Cables Must Be Used 600 ohm balanced out to mixer, tape deck, etc.

  • Page 6

    If this product contains tubesor meters, Peavey warrants thefubes or meters contained in the product to be free from defects in material and workmanship for a period of ninety (90) days from date of purchase, PROVIDED, however, that this limited warranty limitations hereinafter set forth.

Comments to this Manuals

Symbols: 0
Latest comments: