Specifications; Block Diagram - Peavey Express 112S TransTube Operating Manual

SPECIFICATIONS

Rated Power & Load:
Power specs measured with
4 ohms not recommended
Power @ Clipping: (Typically)
Frequency Response:
Hum & Noise:
Greater than 78 dB below rated
power
Power Consumption:
(Domestic)
The following specs are measured
as follows:
Push Bright, Off (Out)
Channel Select Normal (Out)
SWITCH
INPUT
LOGIC
FOOT
SWITCH
CLEAN

BLOCK DIAGRAM

Low&High @ 10
Mid @ 0
Gain & Thrash, Off (Out)
Normal Levels are with normal
volume @ 5
Minimum Levels are with normal
volume @ 10
Impedance: High 2, 1 M ohm
Nominal Input Level: -14 dBV,
Minimum Input Level: -24 dBV,
Maximum Input Level: 0 dBV,
Impedance: High Z,44 K ohms
Nominal Input Level: -8 dBV,
Minimum Input Level: -18 dBV,
Maximum Input Level: 6 dBV,
Effects Send:
preset
Load Impedance: 1 K ohm
or greater
Nominal Output Level: -10 dBV,
HIGH GAIN
PUSH
BRIGHT
Effects Return:
Impedance: High Z, 22 K ohms
Designed Input Level: - 10 dBV,
(Switching jack provides Effects
Send to Effects Return connection
when not used)
System Hum & Noise
Equalization:
Special low, mid, & high passive
type
Push Bright: +6 dB @ 2 kHz
Push Thrash: -20 dB notch @ 1 kHz
in Lead channel
Push Gain: Increases Lead gain
External Footswitch Functions:
Lead Channel Defeat (when selected
with button)
Reverb Defeat
REVERB LEVEL
5
FOOTSWITCH