Viking DGVU2004B–30 Service Manual
Viking DGVU2004B–30 Service Manual

Viking DGVU2004B–30 Service Manual

Built-in gas cooktop

Advertisement

Quick Links

Service
Preferred Service
Manual
This manual is to be used by qualified appliance technicians only.
Viking does not assume any responsibility for property damage
or personal injury for improper service procedures done by an
unqualified person.
Built-in
This Base Manual covers general and
Gas Cooktop
specific information including, but not
limited to the following models:
DGVU2004B–30
DGVU260–36
SMC-0019
June 2011

Advertisement

Table of Contents
loading

Summary of Contents for Viking DGVU2004B–30

  • Page 1 Service Preferred Service Manual This manual is to be used by qualified appliance technicians only. Viking does not assume any responsibility for property damage or personal injury for improper service procedures done by an unqualified person. Built-in This Base Manual covers general and Gas Cooktop specific information including, but not...
  • Page 2: Table Of Contents

    Manifold Pipe Assembly ..........23 Re-igniter Module............24 Terminal Block with Clamp ..........25 Pressure Regulator ............26 Troubleshooting Guide ........... 27 WIRING AND SCHEMATICS DGVU200––4B Wiring Diagram ........28 DGVU260––5B Wiring Diagram ........29 © 2011 Viking Preferred Service...
  • Page 3: Important Information

    “DANGER”, “WARNING” or “CAUTION”. These words mean: CAUTION DANGER VIKING will not be responsible for any injury Immediate hazards which WILL result in severe or property damage from improper service personal injury or death. procedures. If performing service on your...
  • Page 4: Warranty Information

    Viking Range Corporation service agency or representative. This warranty does not apply to commercial usage.
  • Page 5: Warranty Service

    Corporation, 111 Front Street, Greenwood, Mississippi 38930, (888) 845-4641. Provide model and serial number and date of original purchase or closing date for a new construction. For the name of your nearest authorized Viking Range Corporation service agency, call Viking Range Corporation.
  • Page 6: Specifications

    Right rear 12,000 Nat./LP (BTU) 12,000 Nat./LP (BTU) (3.5 Nat./LP (kw)) (3.5 Nat./LP (kw)) Approximate 35 lb. (15.9 kg) 60 lb. (27.2 kg) shipping weight *Go to vikingrange.com for latest specifications © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 7 (18.4 cm) 28-1/2” (72.4 cm) DGVU2600 36-3/4” (93.3 cm) 21” (53.3 cm) 2-13/16” (7.1 cm) 4” (10.2 cm) 7-3/16” (18.4 cm) 34-1/2” (88 cm) *Go to vikingrange.com for latest specifications © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 8: Warnings

    BURN HAZARD Failure to do so can result in burns or electrical To avoid risk of injury, DO NOT touch the glass. shock. The cooktop will get hot during usage. © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 9: Electrical Requirements

    In Massachusetts: A “T” handle type manual gas valve must be installed in gas supply line to the appliance. © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 10 The intake pipe and the shut-off valve should be connected to the regulator to complete the connection. In Massachusetts: This appliance must be installed with a 36” (3-foot) long flexible gas line. © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 11: Model - Serial Number Matrix

    NAT 4” WCP (1246 PA) PROPANE 10” WCP (2492 Pa) SERIAL NUMBER: Q00080 0028 MODEL VFBQ6203T1LSS NUMBER VOLTAGE AMPS SERIAL 030111C0007498 NUMBER 120VAC 0,035 120 VAC / 60 HZ MAXIMUM AMPS 2.2 © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 12: Operation

    Any and all cookware, including Viking cookware, is Rear and Front Burners suitable for use. This is a matter of personal Push in and turn the control knob counter-clockwise choice.
  • Page 13: Service Diagnostics And Procedures

    Service Diagnostics and Procedures DGVU200–4B Parts Location–Exterior Left Grate Burner Head Center Grate Burner Head Right Grate Assembly (4,000 BTU) Assembly (12,000 BTU) Assembly Burner Head Burner Head Control Knob (15,000 BTU) (9,000 BTU) © 2011 Viking Preferred Service...
  • Page 14: Dgvu260-5B Parts Location-Exterior

    Service Diagnostics and Procedures DGVU260–5B Parts Location–Exterior Left Grate Burner Head Center Grate Burner Head Burner Head Right Grate Assembly (4,000 BTU) Assembly (9,000 BTU) (12,000 BTU) Assembly Burner Head Control Knob Burner Head (15,000 BTU) (12,000 BTU) © 2011 Viking Preferred Service...
  • Page 15: Parts Location-Interior

    Spark Plug Spark Plug Spark Plug Burner Assembly Burner Assembly Burner Assembly Micro Switch Spark Plug Spark Plug Manifold Pipe Assembly Gas Valve Gas Valve Gas Valve Note: DVGU260-5B shown. © 2011 Viking Preferred Service © 2011 Viking Preferred Service...
  • Page 16: Main Top Access

    Electronic Re-Igniter Module , Terminal Block with Clamp: 1. Remove burner grates and control knobs. Grates Screw Control Knob 2. Remove burner caps and burner heads. Burner Cap 4. Reverse procedure to reinstall. Note: DVGU260-5B shown. Burner Head © 2011 Viking Preferred Service...
  • Page 17: Spark Plug

    16). 2. Remove wiring connector from spark plug. Spark Plug Connector Burner Assembly 5. Repair/replace spark plug as necessary. 6. Reverse procedure to reinstall. 3. Squeeze spark plug spring and pull to remove. Spring Spring © 2011 Viking Preferred Service...
  • Page 18: Burner Assembly

    5. Repair/replace burner assembly as necessary. 6. Reverse procedure to reinstall. Note: Make sure correct burner assembly size is reinstalled (see Parts Location Exterior, pages 13-14 for correct burner sizes). Note: DVGU260-5B shown. Burner Inlet © 2011 Viking Preferred Service...
  • Page 19: Gas Valve Replacement

    5. Repair/replace gas valve as necessary. 6. Reverse procedure to reinstall. Note: When reinstalling gas valve to manifold pipe assembly, make sure that gas valve Opening fitting and manifold pipe assembly opening align correctly. Gas Valve Fitting Burner Pipe © 2011 Viking Preferred Service...
  • Page 20: Micro Switch

    1. Remove main top (see Main Top Access section, page 16). Micro Switch 2. Remove wiring connectors from micro switch. Micro Switch Connectors 4. Repair/replace micro switch as necessary. 3. Push clips outward to disengage micro switch. 5. Reverse procedure to reinstall Clip © 2011 Viking Preferred Service...
  • Page 21: Re-Grease Gas Valve/Minimum Screw Replacement

    2. Remove micro switch (see Micro Switch section, page 20). 3. Remove gas valve bushing and upper plastic shroud. Clips Screwdriver Bushing Blade Shroud 5. Remove screws and gas valve top. Screw Screw © 2011 Viking Preferred Service...
  • Page 22 Valve Cone Note: Replace in right position at top of valve. Correct Position Notch 6b. Turn the minimum screw counterclockwise to remove. Replace minimum screw. Minimum Screw Valve Cone Note: Check for leaks after reinstallation. © 2011 Viking Preferred Service...
  • Page 23: Manifold Pipe Assembly

    Screw Connectors Connectors Connectors Connectors Remove manifold assembly bracket securing screws. Screw Screw 3. Disconnect burner pipes from valves. Screw Screw 6. Remove securing screws and manifold end bracket. Screw End Bracket Burner Pipe Screw © 2011 Viking Preferred Service...
  • Page 24: Re-Igniter Module

    Screw pipe assembly, make sure that gas valve fitting and manifold pipe assembly opening align correctly. Gas Valve Fitting 4. Repair/replace re-igniter module as necessary. 5. Reverse procedure to reinstall. Note: VGU260-5B shown. © 2011 Viking Preferred Service...
  • Page 25: Terminal Block With Clamp

    3. Remove wiring connectors from terminal block. Screw Clamp Power Cord Clamp 6. Remove and repair/replace terminal block as Connectors Terminal Block necessary. Note: Loosen power cord screws if removing power cord from terminal block. 7. Reverse procedure to reinstall. © 2011 Viking Preferred Service...
  • Page 26: Pressure Regulator

    1. Turn off gas and electric supplies and remove unit from service. 2. From under unit, disconnect gas line to pressure regulator. 3. Disconnect pressure regulator from cooktop. Pressure Regulator 4. Repair/replace pressure regulator as necessary. 5. Reverse procedure to reinstall. © 2011 Viking Preferred Service...
  • Page 27: Troubleshooting Guide

    Dry/clean igniters Burner ignites but flame is Debris/soil on igniter Clean burner head large, distorted, yellow Conversion problem Verify conversion is complete Wrong type gas Verify gas type is proper for range setting (LP or Natural) © 2011 Viking Preferred Service...
  • Page 28: Wiring And Schematics

    Wiring and Schematics DGVU200––4B Wiring Diagram BL/WH WH/RD WH/BK Re-Igniter Module Terminal Block Micro Switches Igniters Ground Neutral 120C AV (Line In) © 2011 Viking Preferred Service...
  • Page 29: Dgvu260--5B Wiring Diagram

    Wiring and Schematics DGVU260––5B Wiring Diagram Re-Igniter Module WH/BK WH/RD Terminal Block Ground Neutral 120C AV (Line In) Micro Switches Igniters © 2011 Viking Preferred Service...

This manual is also suitable for:

Dgvu260–36

Table of Contents