Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Peavey MMA 800T
Summary of Contents for Peavey MMA 800T
- Page 1 Cover for MMA™800T...
- Page 2 Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
-
Page 3: General Description
The program level control regulates the level of this input and the signal is routed through the system bass and treble controls. The MMA 800T is packaged as a stand-alone unit but will also rack-mount into a standard 19" rack with an optional rack-mount kit. - Page 4 HIGH EQ CONTROL (TREBLE) (3): Active equalization control that adjusts the high frequency response. Clockwise rotation boosts highs while counterclockwise rotation provides a cut (reduction) of the high frequencies ( 10 dB). MASTER (4): Controls the overall volume level of the system. PROGRAM LEVEL CONTROL (5): Controls the signal level of the program input.
- Page 5 FUSE (13): WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY.
-
Page 6: Specifications
OUTPUT POWER: +4 dBm (rated output) +17 dBm (maximum) POWER BANDWIDTH: 40 Hz to 20 kHz, +17 dBm, > 0.5% THD FREQUENCY RESPONSE: 20 Hz to 20 kHz 1 dB THD: 0.05% at 1 kHz, rated output S/N RATIO: Master Volume Min: 100 dB Master Volume Max: 77 dB TONE CONTROLS: Bass 10 dB @ 100 Hz... -
Page 7: Block Diagram
Block Diagram WARNING! DO NOT ATTEMPT TO INSTALL THIS UNIT WHILE IT OR ANY CONNECTING UNITS ARE POWERED ON. RISK OF ELECTRICAL SHOCK EXISTS IF ALL UNITS ARE NOT POWERED OFF DURING INSTALLATION. TO PREVENT ELECTRICAL SHOCK OR FIRE HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS- TURE. - Page 9 For further information on other Peavey Architectural Acoustics products, ask your Authorized Peavey Sound Contractor for the appropriate Peavey Architectural Acoustics catalog/publication. Commercial Sound For Permanent Installations Engineered Sound Products For Permanent Installations Be sure to ask about products in the following categories:...
-
Page 10: Limited Warranty
If within one (1) year from date of purchase a properly installed product proves to be defective and Peavey is notified, Peavey will repair or replace it at no charge. (Note: Batteries and patch cords not covered.) “Original purchaser” means the customer for whom the product is originally installed. -
Page 11: Important Safety Instructions
16. The user should not attempt to service this equipment. All service work should be done by a qualified service technician. 17. This product should be used only with a cart or stand that is recommended by Peavey Electronics. 18. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. - Page 12 ® ® ARCHITECTURAL ACOUSTICS® Features and specifications subject to change without notice. Peavey Electronics Corporation 711 A Street / Meridian, MS 39301 / U.S.A. / (601) 483-5365 / Fax 486-1278 ©1995 #80302328 Printed in U.S.A. 12/95...