Even with the application of the relevant
safety regulations and the implementa-
tion of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any
Injuries caused when changing any
parts, blades or accessories.
Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
Impairment of hearing.
Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/battery must be
placed in a well ventilated area when
Symbols on the charger
Read all of this manual carefully before using the
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Short circuit proof safety isolating transformer. The
mains supply is electrically separated from the
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 14
This tool includes some or all of the following features.
1. On/off power switch
4. Pull out crevice tool
5. LED charging indicator
6. Dust bowl
7. Charging base
8. Flip down brush
Switching on and off (Fig. A)
Press the button to turn, on the unit operates in slow
speed, low power mode, conserving the battery life.
Press the button again, and the unit goes to a BOOST
Pressing the button again will turn the product off.