Defrosting Of The Freezer; What To Do If - Electrolux EUF27393X User Manual

24 www.electrolux.com
age the plastics used in this appliance.
For this reason it is recommended that
the outer casing of this appliance is only
cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.

5.2 Defrosting of the freezer

The freezer compartment of this model,
on the other hand, is a "no frost" type.
This means that there is no buildup of
frost when it is in operation, neither on the
internal walls nor on the foods.
The absence of frost is due to the contin-
uous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.

6. WHAT TO DO IF...

During operation of the appliance some
smaller but annoying trouble can often oc-
cur, which does not require calling a tech-
nician out. In the following chart informa-
tion is given about them to avoid unnec-
essary charges on service.
The operation of the appliance
goes with certain sounds (com-
pressor and circulating sound).
This not means a trouble, but a
normal operation.
Problem
The appliance is
noisy.
The buzzer sounds.
The Alarm icon
flashing.
Downloaded from Fridge-Manual.com Manuals
5.3 Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
• disconnect the appliance from elec-
• remove all food
• defrost (if foreseen) and clean the appli-
• leave the door/doors ajar to prevent un-
If the cabinet will be kept on, ask some-
body to check it once in a while to pre-
vent the food inside from spoiling in case
of a power failure.
Possible cause
The appliance is not sup-
ported properly.
The cushion spacers loca-
ted between the back of
the cabinet and the pipes
come loose.
The temperature in the
freezer is too high.
tricity supply
ance and all accessories
pleasant smells.
The appliance operates discontin-
uously, so the stopping of com-
pressor does not mean being no
current. That is why you must not
touch the electrical parts of the
appliance before breaking the cir-
cuit.
Solution
Check if the appliance
stands stable (all feet and
wheels should be on the
floor). Refer to "Levelling".
Put them back in place
again.
Refer to "High Temperature
Alarm".