Installation - Electrolux EN3850DOX User Manual

22 www.electrolux.com
Problem
The lamp does not
work.
"dEMo" appears on
the display.
The buzzer sounds.
Upper or lower
square is shown in
the temperature dis-
play.
As much as the advice does not lead to result, call the nearest brand-mark service.
8.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
8.2 Closing the door
1. Clean the door gaskets.

9. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The appliance is in dem-
onstration mode.
The door is not closed
correctly.
An error has occurred in
measuring the tempera-
ture.
2.
3.
Cli-
mate
class
SN
N
ST
T
Solution
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Keep pressed approxi-
mately 10 sec the Mode
button since a long sound
of buzzer is heard and the
display shut off for a short
while: appliance start works
regularly.
Refer to "Door open
alarm".
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C