Download  Print this page

Peachtree 600 Instruction Manual

Progrip circular saw plate
Hide thumbs
   

Advertisement

The ProGrip System Saw Base gives you total control for straight-line action. Attaches to your
Saw with fasteners supplied by you depending on the saw plate thickness. This UHMW plastic
base provides smooth long lasting service.
Using The ProGrip Saw Base
The UHMW Saw Base can be use on any length ProGrip Straight edge clamp. The base can be
used on either the right or left side of the clamp to make straight cuts with your saw.
If your Pro-Grip Saw Base comes with locking knobs leave the locking knobs loose enough so
the base will slide smoothly though its full travel.
Saw Mounting Instructions
Step 1
Unplug and remove saw blade from the saw.
(See Figure 1)
ProGrip Circular Saw Plate
Instruction Manual For
This Instruction Manual is a general set of instruction
for mounting a circular saw on the Pro-Grip Saw Base
Plate and Pro-Grip Universal Plate. All circular saws are
not the same and some modification maybe required to
mount your saw. Please read the entire set instructions
before beginning.
CAUTION:
Please read, understand, and follow all manufactur-
ers instructions, guidelines and owners manuals that
come with your power tools. Peachtree Woodworking
Supply, Inc. and its subsidiaries assume no liability
for accidents or injuries caused by improper use of
this product.
NOTE: BE SURE TO UNPLUG YOUR SAW
Part # 600 /605
Figure 1

Advertisement

Table of Contents
loading

  Related Manuals for Peachtree 600

No related manuals

  Summary of Contents for Peachtree 600

  • Page 1 Using The ProGrip Saw Base The UHMW Saw Base can be use on any length ProGrip Straight edge clamp. The base can be used on either the right or left side of the clamp to make straight cuts with your saw.
  • Page 2 1/4” flat head screws (Not Included). The saw base plate will have to be drilled for these mounting screws. Check both sides of the saw base plate for clear flat areas to drill for the mounting screws. From the bottom side of the saw base plate mark the selected areas on the masking tape applied.
  • Page 3 Step 7 Place the saw on the tape runners and position the saw so that the edge of the saw is in line with the edge of the Pro- Grip Saw Base and centered to the length of the Pro-Grip Saw Base.
  • Page 4 (See Figure 12) With the saw mounted to the Pro-Grip Saw Base check to insure that the edge of the saw is even with the edge of the Pro-Grip Saw Base and the wing nuts a are secure. These two edge must be even to insure that the saw will cut parallel to the Pro-Grip Straight Edge Clamp.

This manual is also suitable for:

605605