Injection Nozzle; Injection Nozzle Inspection; Spray Condition; Injection Nozzle Adjustment - Isuzu A-4JA1 Workshop Manual

Industrial diesel engine
Table of Contents

Advertisement

1
2
2
3
4

Injection Nozzle

Injection Nozzle Inspection

Use a nozzle tester to check the injection nozzle opening
pressure and the spray condition.
If the opening pressure is above or below the specified
value, the injection nozzle must be replaced or recondi-
tioned.
If the spray condition is bad, the injection nozzle must be
replaced or reconditioned.
Injection Nozzle Opening Pressure
3

Spray Condition

(1) Correct
(2) Incorrect (Restrictions in orifice)
(3) Incorrect (Dripping)

Injection Nozzle Adjustment

Retaining Nut Torque
1
Adjusting Shim Availability
Total No. of Shims
WARNING:
TEST FLUID FROM THE INJECTION NOZZLE TESTER
WILL SPRAY OUT UNDER GREAT PRESSURE. IT CAN
EASILY PUNCTURE A PERSON'S SKIN. KEEP YOUR
HANDS AWAY FROM THE INJECTION NOZZLE TESTER
AT ALL TIMES.
185 (2,630/18.1)
1. Clamp the injection nozzle in a vise.
2. Use a wrench to remove the injection nozzle retain-
ing nut.
3. Install the injection nozzle 1 , the push rod 2 , the
spring 3 , and adjusting shim 4.
4.0 – 5.0 (28.9 – 36.2/39.2 – 49.0)
4. Attach the injection nozzle holder to the injection
nozzle tester.
5. Apply pressure to the nozzle tester to check that the
injection nozzle opens at the specified pressure.
If the injection nozzle does not open at the specified
pressure, install or remove the appropriate number
of adjusting shims to adjust it.
Range
Increment
(Reference)
Removing or installing one shim will increase or
decrease the nozzle opening pressure approximately
3.77 kgf/cm
(53.6 psi/370kPa).
2
MAINTENANCE
kgf/cm
2
(psi/MPa)
kgf·m(lb.ft./N·m)
mm(in.)
0.50 – 1.50 (0.02 – 0.06)
0.025 (0.001)
40
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4ja1A-4jb1

Table of Contents