Yamaha XT 125R 2005 Service Information page 8

Component N. Description
90890-01274 (1) Tool for Drive Shaft Installation
90890-01275 (2)
Drive Shaft Pin
90890-01278 (3)
Adaptor (M12)
(*) 90890-01326 T-tool
The T-tool is used to hold the shock absorber rod when it
is removed or installed.
(*) 90890-01367 Fork Clamp
(*) 90890-01381
Fork Clamp Fitting
The fork clamp fitting is used to install the fork cross.
(*) 90890-01403 Nut Ring Wrench
This wrench is used to loosen and tighten the nut ring of
the handlebar.
90890-03112 Pocket Tester
The pocket tester is required to check the electrical
system.
(*) Indications from Yamaha are required about the compatibility of the components above. If they are not compatible, ID codes and drawings
of new components are required. Otherwise, Yamaha should state which components are to be excluded from this Manual.
GENERAL INFORMATION
8
GEN
INFO
Picture