Installation; Prerunning - Sanyo MIR-162 Service Manual

INSTALLATION

1. Remove the packaging materials and tapes
Remove all transportation packaging materials and tapes. Open the doors and ventilate the unit. If the
outside panels are dirty, clean them with a neutral detergent and wipe it up with a wet cloth.
2. Adjust the leveling legs
Extend the leveling legs by rotating them counterclockwise so they contact the floor or bench. Ensure
the unit is level.
3. Ground (earth)
WARNING
Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is
not grounded, it is necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.

PRERUNNING

When using the unit for the first time after purchasing, operate the unit without objects inside.
1. Install the racks in the chamber.
2. Set the temperature at 60
3. Leave the unit as it is until the chamber temperature is cool enough.
4. Ventilate the room when opening the chamber door as the smoke with a strong odor is exhausted.
5. Keep the chamber door opened for a while until the odor is eliminated.
Note:
Some odor may be remained after prerunning. Such residue is eliminated gradually during usage.
• With use, the inner surfaces, shelves and the separation plate becomes lightly colored due to the smoke
generated inside. This is a natural coloration; please acknowledge this.
• This unit has been tested at the factory before shipping. Sometimes light lines and/or coloration can be
detected inside; however, this is a new product, please acknowledge this.
o
C and operate the unit for 20 minutes.
- 35 -
12