Summary of Contents for Paxar Four Station Charger 6094
-
Page 1: Operating Instructions
6094 Four Station Charger Operating Instructions TC6094OI Rev. BA 4/02 ©2002 Paxar Corporation. All rights reserved. - Page 2 A prescrites dans le Réglement sur le brouillage radioélectrique édicte par le ministère des Communications du Canada. Trademarks Monarch and PATHFINDER are registered trademarks of Monarch Marking Systems, Inc. Paxar is a trademark of Paxar Corporation. 6094 is a trademark of Monarch Marking Systems, Inc. WARNING...
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Save These Instructions This manual contains important safety and operating instructions for the 6094 charger. Before using the 6094 charger, please read all instructions and caution markings on: the charger. the battery handle. the printer. The 6094 charger is for charging PATHFINDER handles only. - Page 4 6094 Operating Instructions Do not use an extension cord unless absolutely necessary. If an extension cord is used, make sure the wire is 18 gauge or larger. the pins on the plug of the extension cord are the same number, size, and shape as those of the plug on the charger.
-
Page 5: Table Of Contents
Table of Contents 1. Overview...1 Charging Time ... 1 Convenience Features ... 2 2. Installing the Charger ... 3 Setting the Power Supply ... 3 Wall Mount Installation ... 5 Power On Test ... 6 3. Charging Handles ... 7 4. - Page 6 6094 Operating Instructions...
-
Page 7: Overview
1. Overview The 6094 charger is a "fast charge" accessory for charging and storing PATHFINDER battery handles. There are four charging stations on the charger. Each station charges independently, which means you can attach battery handles at anytime. Charging Time Charging time varies depending upon the capacity rating of the battery handle and its usage. -
Page 8: Convenience Features
6094 Operating Instructions Convenience Features Additional features are: switchable power supply which lets you select 100, 120, 220, or 240 VAC for your operating area. charging status indicator light for each charging station. replaceable fuses. Familiarize yourself with the different parts of the 6094 charger. Fuse Box Power Switch... -
Page 9: Installing The Charger
2. Installing the Charger The charger may be mounted to the wall or set on a sturdy table. Before installing the charger set the power supply for the voltage in your area. select a location for wall mounting or table top use. perform the power on test. - Page 10 6094 Operating Instructions Carefully pull the fuse box straight out. Fuses are attached, so be careful not to drop or jolt the fuses. Make sure you are using the correct fuses for the voltage you select. Using a screwdriver, pull the power selector straight out. Rotate the power selector to the setting required.
-
Page 11: Wall Mount Installation
Wall Mount Installation To install the charger, you will need hardware appropriate for the wall surface. the weight of the charger with 4 handles (approximately 9.8 lb/4.4 kg). screws no larger than No. 10 wood screw. Select a location within 6 feet of an electrical outlet. Use the bracket of the charger to mark the holes where the unit is to hang. -
Page 12: Power On Test
6094 Operating Instructions Power On Test Whenever you turn the power on, the charger will go through a self-test cycle which takes a few seconds. During this test, you’ll see the status indicators flash in the following sequence: GREEN power light is on. Each station, starting with station one, flashes GREEN to RED. -
Page 13: Charging Handles
3. Charging Handles To begin charging... Check the power light to make sure the power is on. Power Light Power Switch Slide the battery handle completely into the charging station. Status Indicator Charging Station... - Page 14 6094 Operating Instructions The status indicator will slowly flash green to indicate the battery handle is properly installed. During the charging cycle, the status indicator will change. Use the color of the status indicator and whether it is solid, flashing slowly, or flashing quickly to determine the meaning of the indicator.
-
Page 15: Troubleshooting
4. Troubleshooting This chapter includes common problems which may occur and instructions for replacing the fuses. Problems and Solutions This section helps you correct some problems that may occur. If you cannot fix a problem, please contact Monarch Service. U.S. Customers call TOLL FREE 1-800-231-7700 International Customers contact your Pitney Bowes or Monarch Marking Systems representative. - Page 16 6094 Operating Instructions Problem Status indicator does not light up when a battery handle is attached. Battery handle will not charge. Charger is warm. A status indicator is quickly flashing red and the rest of the indicators have no light. All status indicators quickly flash green/red.
-
Page 17: Replacing Fuses
Replacing Fuses If the fuses need replacing, you’ll need: 1A fuses for 120V and 100V..or..5A fuses for 220 and 240V. When the charger is facing you, the fuse box is located on the left side of the charger beside the power switch. Turn the power OFF and unplug the power cord. -
Page 18: Specifications
6094 Operating Instructions Specifications Dimensions: Height Width Depth Weight (with cord) Power: Internal switchable power supply (100, 120, 220, 240 VAC/ 50 Hz. nominal) Replaceable dual fusing 1A fuses (Monarch part #PB02282108) for 100 and 120 VAC models .5A fuses (Monarch part #PB02282107) for 220/240 VAC model High output current - 500 mA (+/- 10%) per charging station... - Page 20 For supplies, service or assistance call: TOLL FREE: 1-800-543-6650 (In the U.S.A.) 1-800-263-4650 (In Canada) www.paxar.com Published by the Technical Communications Department. Printed in U.S.A.