Installation; The Model 1001R14 Rack Chassis; The Rack Power Supply - Patton electronics IM2RC/I-100B User Manual

This section describes the NetLink Model 1001R14 rack chassis.
Included are installation instructions for the IM2RC/I-100B rear card, plus
ethernet and line interface connections to the IM2RC/I-100B card.
Please refer to the appropriate function card (i.e. 3088RC) user manual
to configure and install the function card.

5.1 THE MODEL 1001R14 RACK CHASSIS

The Model 1001R14 Rack Chassis (Figure 5) has fourteen short range
modem card slots, plus its own power supply. Measuring only 3.5" high,
the Model 1001R14 is designed to occupy only 2U in a 19" rack. Sturdy
front handles allow the Model 1001R14 to be extracted and transported
conveniently.
Figure 5. Model 1001R14 Rack Chassis with power supply

The Rack Power Supply

The Patton NetLink rack system is designed to allow single or redundant
(dual) power supplies. Using the same mid-plane architecture as the
function/rear cards, the front function card and the power supply slide in
from the front, while the rear card and power entry modules slide in from
the rear. They plug into one another in the middle of the rack. The front
card is then secured by thumb screws and the rear card by conventional
metal screws..
WARNING

5.0 INSTALLATION

There are no user-serviceable parts in the power supply
section of the Model 1001R14. Voltage setting changes
and fuse replacement should only be performed by
qualified service personnel. Contact Patton Electronics
Technical support at (301) 975-1007 for more informa-
tion.
12