Dry Ironing; Steam Ironing; Burst Of Steam - Russell Hobbs RHI101 Instructions And Warranty

SPRAYING
1. This function can be used any time and does not affect
any setting.
Fill the water tank as described in "How to Fill Water".
2.
3. Aim the nozzle to the garment.
4. Press the Spray Button.
Note: It may be necessary to press the spray button a few times to start this function.

DRY IRONING

1. Unwind and straighten the power cord.
2. Connect the appliance to a suitable mains supply outlet.
3. Turn the Temperature Dial on the iron in a clockwise direction, select '
-
label.
4. The Pilot light glows indicating the iron is switched on.
5. The Pilot Light goes off when the required temperature for the iron is reached.
6. The appliance is now ready for use.
7. When finished with your ironing, turn the iron to the off position/MIN and
disconnect the power cord from the mains supply outlet.
8. When the appliance cools down completely, store it in a safe place.
9. Do not wrap the cord around the iron.

STEAM IRONING

1. Unwind and straighten the power cord.
2. Fill the water tank as described in "How to Fill Water"
3. Connect the appliance to a suitable mains supply outlet.
4. Turn the Temperature Dial in clockwise direction to '
setting or to 'Max' setting. (For optimum steam quality, do not use
1 dot or 2 dots setting for steam ironing); The Pilot light glows,
indicating the iron is switched on.
5. The Pilot light goes off when the required temperature is reached.
6. The appliance is now ready for use.
7. Move the Variable Steam Control to give the desired amount of steam.
8. Turn the Temperature Dial in an anti-clockwise direction to "Min", and then the iron
will switch off.
9. Disconnect the iron from the mains supply outlet.
10. When the appliance cools down completely, store it in a safe place.
11. Do not wrap the cord around the iron.

BURST OF STEAM

This function provides an extra amount of steam to remove
stubborn wrinkles.
Fill the water tank as described in "How to Fill Water"
1.
2. Connect the appliance to a suitable mains supply outlet.
Turn the Temperature Dial to '
3.
setting. The Pilot light glows, indicating the iron is switched on.
4. The Pilot light goes off when the required temperature is
-3) according to the recommendation of the garment
' (3 dots) setting or to 'Max'
(
' (3 dots)
-1),