Remove the footpeg bracket bolts and bracket.
(This position is standard.)
A. Footpeg Bracket Bolts
B. Footpeg Bracket
Apply a non-permanent locking agent to the
Select either footpeg position and tighten the
bracket with the two bolts.
Footpeg Bracket Bolts (Upper):
34 N·m (3.5 kgf·m, 25 ft·lb)
Footpeg Bracket Bolts (Lower):
16.5 N·m (1.68 kgf·m, 12.2 ft·lb)
Apply grease to the pivot pin.
Install the footpeg, spring and pivot pin. Insert the
pivot pin from the front.
MAINTENANCE AND ADJUSTMENT 101
Position the spring ends as shown in the figure.
Install the washer and new cotter pin.
Bend the longer end of the cotter pin.
A. Pivot Pin
B. Spring Ends
D. Cotter Pin
Install the footpegs with same height on both
sides. Do not ride the motorcycle with footpegs in-
Adjust the positions of the shift pedal and the
brake pedal to suit the rider's preference.
Installing the footpegs in the lower position will re-
duce the amount of ground clearance and lean