Download  Print this page

Advertisement

Remove the handlebar holder nuts, washers and
handlebar holders.
A. Handlebar Holder Nuts
B. Washers
C. Handlebar Holder
Select the handlebar position and install the
dampers into the holes of the steering stem head
so that the flat surface of the dampers fit the sur-
face of the steering stem head holes.
Replace the handlebar holder nuts with new ones.
Install the handlebar holder in the suitable direc-
tion.
Put the handlebar on the handlebar holder.
Temporarily install the handlebar clamps.
Hand tighten the handlebar clamp bolts.
Tighten the handlebar holder nuts.
MAINTENANCE AND ADJUSTMENT 99
Tightening Torque
Handlebar Holder Nuts:
34 N·m (3.5 kgf·m, 25 ft·lb)
A. Dampers
B. Flat Surfaces
Position the handlebar and use the gauge marks
to check its alignment in the clamps. There should
be equal marks showing on each side of the
clamps.
Tighten the front and rear handlebar clamp bolts
equally. If the handlebar clamps are correctly in-
stalled, there will be even gaps on the front and
rear sides of the clamp after the bolts are torqued.
Tightening Torque
Handlebar Clamp Bolts:
25 N·m (2.5 kgf·m, 18 ft·lb)

Advertisement

Table of Contents

This manual is also suitable for:

Kx450f 2014Kx450f

Comments to this Manuals

Symbols: 0
Latest comments: