Recording - Sony STR-GA9ESG Operating Instructions Manual

If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down
to the closest covered value.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 10 kHz intervals (to change to 9 kHz intervals, see
page 54)
For the on-screen operations, see page 25
Receiving broadcasts by scanning stations
(automatic tuning)
1
Select TUNER.
The last received station is tuned in.
2
Press DISPLAY so that the frequency appears in
the display.
3
Press FM/AM to select FM or AM.
4
Press INDEX + or –.
Press the + button for a higher station number;
press the – button for a lower one. When you tune
past either end of the band, the receiver
automatically jumps to the opposite end and
continues scanning in the same direction. Every
time a station is received, the receiver stops
scanning. To continue scanning, press the button
again.
For the on-screen operations, see page 25.
Presetting
1
Turn FUNCTION to select "TUNER".
The last received station is tuned in.
2
Tune in the station you want.
3
Press MEMORY.
"MEMORY" appears for a few seconds.
Do steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A", "B" or
"C" appear in the display.
5
Press the number you want to use (0 to 9).
If "MEMORY" goes out before you specify the preset
number, start again from step 3.
6
Repeat steps 2 to 5 to preset other stations.
Using the Controls on the Front Panel
To change a preset station
Preset a new station on the number you want to change.
Note
If the AC power cord is disconnected for about one week,
the preset stations will be cleared from the receiver's
memory, and you will have to preset the stations again.
For the on-screen operations, see page 26.
Tuning preset stations (preset tuning)
1
Select TUNER.
The last received station is tuned in.
2
Press SHIFT to select a memory page (A, B or C),
then press the number.
For example, select A and then press 7 to tune in
the station preset as A7.
You can also tune by scanning the preset stations
Press TUNER and then DISPLAY so that the frequency
display appears. Then press PRESET + or – to select the
station you want. Each time you press the buttons, the
preset numbers change as follows:
nA1 A2 ...A9 A0 B1 B2 ...B9 B0N
nC0 C9...C2 C1N
For the on-screen operations, see page 26.

Recording

1
Turn FUNCTION to select the program source to
be recorded.
2
Set the component to be ready for playing.
For example, insert a CD into the CD player.
3
Insert a blank tape into the recording deck (or
VCR, etc.) and adjust the recording level, if
necessary.
4
Start recording on the recording deck and then
start playing the component.
You can monitor the sound being recorded
If you connected a 3-head tape deck to the TAPE
MONITOR jacks, press TAPE MONITOR. "TAPE"
appears in the display and you can hear the sound
being recorded.
(continued)
47