Stopping; Taking Out Of Operation - Atlas Copco ga55+ Instruction Book

Instruction book
service plan interval has been exceeded or if a service level for a monitored component has been exceeded.
Carry out the service actions of the indicated plans or replace the component and reset the relevant timer, see
section Service menu.
7.7

Stopping

Elektronikon regulator
Procedure
Step Action
Press stop button (9). Automatic operation LED (8) goes out and the compressor stops after
-
30 seconds of unloaded operation.
To stop the compressor in the event of an emergency, press emergency stop button (10).
Alarm LED flashes (7).
On compressors with an Elektronikon® Graphic controller:
-
Do not use emergency stop button (10) for normal stopping! See also section
Emergency stop button
- Close air outlet valve (AV), see section
On water-cooled compressors:
-

7.8 Taking out of operation

Warning
The operator must apply all relevant
9096 3313 00
•
Remedy the fault and unlock the button by pulling it out.
•
Navigate to the Stop icon on the display by means of the navigation keys (3/4) and
press the Select key.
Press reset.
.
•
Close the cooling water inlet valve.
•
If freezing temperatures can be expected, drain the cooling system completely.
Control panel Eledtronikon Graphic
Introduction.
Safety precautions.
117