Technical Data; Functional Description - Bosch PMF 180 E Multi Original Instructions Manual

Do not treat the surface to be worked with
solvent-containing fluids. Materials being
warmed up by the scraping can cause toxic
vapours to develop.
Exercise extreme caution when handling
the scraper. The accessory is very sharp;
danger of injury.
Products sold in GB only: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should
never be inserted into a mains socket else-
where.
Products sold in AUS and NZ only: Use a re-
sidual current device (RCD) with a rated re-
sidual current of 30 mA or less.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
Intended Use
The machine is intended for sawing and cutting
wooden materials, plastic, gypsum, non-ferrous
metals and fastening elements (e.g. nails, sta-
ples). It is also suitable for working soft wall tiles
as well as for dry sanding and scraping of small
surfaces. It is especially suitable for working
close to edges and for flush cutting. The power
tool must be used with Bosch accessories only.
Bosch Power Tools
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Thumbwheel for orbit frequency preselection
3 Vacuum connection
4 Vacuum hose*
5 Venting slots
6 Tool holder
7 Plunge saw blade
8 Clamping bolt with washer
9 Allen key
10 Sanding plate
11 Sanding sheet
12 Segment saw blade
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Technical Data

Multi-function tool
Article number
Preselection of orbital
stroke rate
Rated power input
Output power
No-load speed n
0
Oscillation angle,
left/right
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
English | 15
PMF 180 E
3 603 A00 0..
W 180
W 74
-1
min 15000–21000
° 1.4
kg 1.2
/II
2 609 000 229 | (19.1.09)