Operation - Craftsman 315.FS2600 Operator's Manual

INSTALLING GRINDING WHEEL
See Figure 2, page i.
DANGER:
Use ONLY Type 27 depressed center
wheels (such as the one provided with this product).
NEVER attach a Type 1 straight or cut-off wheel
to this angle grinder. Use for any other purpose is
not recommended and creates a hazard, which will
result in serious injury.
TYPE 27 − OK TO USE
DANGER:
Never attach a wood cutting or
carving blade of any type to this grinder. It is only
designed for grinding and sanding. Use for any
other purpose is not recommended and creates a
hazard, which will result in serious injury.
WARNING:
Thoroughly inspect a new grinding
wheel before you install it on the grinder.
• Tap lightly around the wheel using a wooden
hammer.
• Listen carefully to the resulting sounds. Places
with fissures or cracks will result in a different
sound.
Do not use a wheel containing fissures or cracks.
When you install a new grinding wheel, carry out a
no load revolution test of approximately one minute
with the grinding wheel facing a safe direction, i.e.,
away from people or objects.
 Depress the spindle lock button and rotate the clamp
nut until the spindle locks.
WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
serious injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer
of this product. The use of attachments or
accessories not recommended can result in serious
personal injury.
ASSEMBLY
TYPE 1 − DO NOT USE

OPERATION

9 - English
NOTE: To prevent damage to the spindle or spindle
lock, always allow motor to come to a complete stop
before engaging spindle lock.
 Loosen and remove the clamp nut from the spindle. Do
not remove the disc flange.
 Make sure the flats on the bottom of the disc flange are
engaged with the flats on the spindle.
 Place the grinding wheel over the spindle.
 Thread the clamp nut on the spindle with the flat side
of the nut facing up.
 Fit the raised, small diameter portion of the clamp nut
into the hole in the wheel and finger tighten.
WARNING:
Always install a grinding wheel with
the depressed center against the disc flange. Failure
to do so will cause the grinding wheel to crack when
tightening the clamp nut. This could result in serious
personal injury because of loose particles breaking
off and being thrown from the grinder. Do not over-
tighten.
Depress the spindle lock button and rotate the wheel

clockwise until the spindle locks in position.
Tighten the clamp nut securely with the wrench

provided. Do not overtighten.
INSTALLING THE SIDE HANDLE
See Figure 3, page i.
The side handle can be installed on the top, left, or right
side of the grinder, depending on operator preference. The
handle must always be used to prevent loss of control and
possible serious injury.
 Insert the side handle into the desired operating posi-
tion.
 Turn the side handle clockwise to securely tighten.
APPLICATIONS
You may use this product for the purpose listed below:
 Grinding metals
 Sanding wood or metal surfaces
This product will accept Craftsman 19.2 V lithium-ion
battery packs and Craftsman 19.2 V nickel-cadmium
battery packs.
For complete charging instructions, see the Operator's
Manuals for your battery pack and charger models.