Table of Contents
Advertisement
4.3.
Assembly procedure
Important:
When tightening the screw, use a torque driver (RFKZ0456)
by ordering the screwing order with specified torque
described in each step.
4.3.1.
Installation of the Mount contact
unit
1. Connect FPC to 1 connector.
4.3.2.
Installtion of the Lens P.C.B.unit
and the Mount contact unit
1. Connect FPCs to 4 connectors.
4.3.3.
Installation of the Earth plate
1. Tighten 1 screws (E) by using the torque driver with spec-
ified torque.
(Torque Driver : RFKZ0456)
(Torque : 11.8±1.2N ･ cm)
4.3.4.
Installation of the Rear frame unit
1. Tighten 1 screws (D) by using the torque driver with spec-
ified torque.
(Torque Driver : RFKZ0456)
(Torque : 11.8±1.2N ･ cm)
Page 13
Advertisement
Table of Contents
