Troubleshooting - Silvercrest SHBS 600 A1 Operating Instructions Manual

BB*5$B%ERRN 6HLWH  'LHQVWDJ  1RYHPEHU    
Removing the battery
• This device is operated with a rechargea-
ble lithium-ion battery, which you must re-
move before disposing of the device.
• You must be technically minded to re-
move the battery, otherwise there is the
danger of injuring yourself. If you do
not have any experience with tools, you
should have the batteries removed by a
person who is qualified to do this.
DANGER from batteries!
~ Ensure that the battery is not damaged
as you remove it. Fire hazard!
~ The removed battery must not be disas-
sembled.
~ Never short-circuit the battery. The con-
tacts on the removed battery must not
be connected by metallic objects. The
battery may overheat and explode.
~ Only remove the battery to dispose of
the device. The device is destroyed by
removing the battery. Never try to oper-
ate a disassembled device.
1. Disconnect the device from the mains.
2. Switch on the device and let it run until
the battery is empty.
3. Figure E: remove the attachment|3
from the hair and beard trimmer|4 by
pressing it with the thumb towards the
rear.
4. Figure G: use a Phillips screwdriver to
release the 3 screws on the back and
on the top end of the device.
5. Figure H: use a screwdriver to lever
open the side seam and unfold the two
halves of the housing apart.
6. Figure I: release the connections be-
tween the battery and the board with a
pair of pliers/wire cutters. Remove the ex-
posed battery. Take the battery and the
device separately to suitable disposal.
46 GB
The lithium-ion battery used
for this device may not be
treated as household waste.
The battery must be disposed
of properly. Contact battery
distributors or local waste dis-
posal points for this.

10. Troubleshooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
Do not attempt to repair the device
yourself under any circumstances.
Possible causes /
Fault
• Has the device been
connected to the
No function
power supply?
• Is the battery empty?
Trimmer attach- • Has the attachment
ment|3 starts been cleaned, and
with difficulty oiled if necessary?
Li-ions
Action