AEG HC652601EB User Manual page 15

Problem
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
comes on.
comes on.
comes on.
Possible cause
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The highest heat setting is
set.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
The electrical connection is
incorrect. The supply voltage
is out of range.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
The cooling fan is blocked.
ENGLISH
Remedy
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Speak to a qualified electri-
cian to check the installation.
Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to "Hints and tips"
chapter.
Check if objects block the
cooling fan. If comes on
again, speak to an Author-
ised Service Centre.
15