Black & Decker MTRT8 Original Instructions Manual page 8

ENGLISH
Keep blades sharp. Dull or damaged blades
u
may cause the router to swerve or stall under
pressure. Always use the appropriate type of
router bit for the workpiece material and type of
cut.
Do not touch the workpiece or the blade
u
immediately after operating the tool. They can
become very hot.
Be aware of hidden hazards, before cutting into
u
walls, floors or ceilings, check for the location
of wiring and pipes.
The blade will continue to move after releasing
u
the switch. Always switch the tool off and wait
for the router blade to come to a complete
standstill before putting the tool down.
@
Warning! Contact with, or inhalation
of dusts arising from cutting applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
Thoroughly remove all dust after routing.
u
8
(Original instructions)
Only use router bits with a shank diameter
u
equal to the size of the collet installed in the
tool.
Only use router bits suitable for the no-load
u
speed of the tool.
Never use router bits with a diameter exceed-
u
ing the maximum diameter specified in the
technical data section.
Do not use the tool in an inverted position.
u
Do not attempt to use the tool in a stationary
u
mode.
Take special care when routing where the paint
u
is possibly lead based or when routing some
woods which may produce toxic dust:
Do not let children or pregnant women enter
u
the work area.
Do not eat, drink or smoke in the work area.
u
Dispose of dust particles and any other
u
debris safely.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.