Page 1
® Rear Connector Plate and Modular DSU V.35 Adapter Installation Instructions Document Number 3000-A2-GZ41-50 July 1999 Overview This document describes the installation procedure for the rear connector plate (Feature Number 3000-F1-021) and the modular Data Service Unit (DSU) V.35 adapter. A rear connector plate is used with a modular DSU or a COMSPHERE 3800 Series modem which has gold contacts on the rear edge of its circuit card (Figure 1).
Page 2
Then, insert the circuit card into the top and bottom circuit card guides for the slot that contains the rear connector plate. Non-Modular Devices Figure 2. Rear View of the COMSPHERE 3000 Series Carrier Model 3511 DSU Rear Connector Plates July 1999 Screw 25-Pin...
Page 3
4. Aligning the circuit card with the rear connector plate, slide the DSU into the slot until the connectors seat firmly into the back of the carrier. 5. Press the faceplate latch to secure the DSU in the carrier, rotate the circuit pack lock into the closed position, and tighten the screw.
Page 4
For additional information concerning warranty, sales, service, repair, installation, documentation, training, distributor locations, or Paradyne worldwide office locations, use one of the following methods: Internet: Visit the Paradyne World Wide Web site at www.paradyne.com. (Be sure to register your warranty there. Select Technical Support Warranty Registration.