Yamaha YK250XGC Installation Manual page 12

3. Warning label 3 (SCARA robots, Cartesian robots)
IMPROPER InSTallaTIOn OR OPERaTIOn May CaUSE SERIOUS InjURy.
bEfORE InSTallIng OR OPERaTIng ThE RObOT, REaD ThE ManUal anD InSTRUCTIOnS On ThE WaRnIng labElS
anD UnDERSTanD ThE COnTEnTS.
4. Warning label 4 (SCARA robots)
Do not remove the parts on which Warning label 4 is attached.
Doing so may damage the ball screw.
5. "Read instruction manual" label (Controller)*
Refer to the manual.
* This label is attached near the power input connector on the front panel.
S-4
取扱説明書参照
READ INSTRUCTION
MANUAL
Instructions on this label
• Be sure to read the warning label and this manual
carefully to make you completely understand the
contents before attempting installation and operation
of the robot.
• Before starting the robot operation, even after you
have read through this manual, read again the
corresponding procedures and "Safety instructions"
in this manual.
• Never install, adjust, inspect or service the robot in
any manner that does not comply with the
instructions in this manual.
Instructions on this label
The Z-axis ball screw will be damaged if the upper end
mechanical stopper on the Z-axis spline is removed or
moved. Never attempt to remove or move it.
Instructions on this label
This indicates important information that you must
know and is described in the manual.
Before using the controller, be sure to read the manual
thoroughly.
When adding external safety circuits or connecting a
power supply to the controller, read the manual
carefully and make checks before beginning the work.
Connectors must be attached while facing a certain
direction, so insert each connector in the correct
direction.
90K41-001290
90K41-001520
93005-X0-00