Operating Instructions - Dell E773c Series Service Manual

This procedure gives you instructions for installing and using the Color display.
1. Position the display on the desired operation and plug the power cord into a convenient AC
outlet. Three-wire power cord must be shielded and is provided as a safety precaution as it
connects the chassis and cabinet to the electrical conduit ground. If the AC outlet in your
location does not have provisions for the grounded type plug, the installer should attach the
proper adapter to ensure a safe ground potential.
2. Connect the 15-pin color display shielded signal cable to your signal system device and lock
both screws on the connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3. Apply power to the display by turning the power switch to the "ON" position and allow about
thirty seconds for display tube warm-up. The Power-On indicator lights when the display is on.
4. With proper signals feed to the display, a pattern or data should appear on the screen, adjust
the brightness and contrast to the most pleasing display.
5. This monitor has power saving function following the VESA DPMS. Be sure to connect the
signal cable to the PC.
6. If your color display requires service, it must be returned with the power cord.

3. OPERATING INSTRUCTIONS

1
6
11
15 - Pin Color Display Signal Cable
DESCRIPTION
RED
GREEN
BLUE
NC
SFTC
GND-R
GND-G
GND-B
7
5
10
15
PIN NO.
9. 5V
10. SYNC. GND
11. NC
12. SDA
13. HORIZ. SYNC
14. VERT. SYNC (＊VCLK)
15. SCL
DESCRIPTION