Environmental Specifications; Heat Output And Air Flow - HP HPE XP P9500 Manual

*1 (right): When connected correctly, one of the four PDUs can supply power to the DKC-DKU
rack.

Environmental specifications

Table 13 (page 26)
disk array.
Table 13 P9500 environmental specifications
Item
Temperature
Relative Humidity
Max. Wet Bulb
Temperature
(Deviation per hour)
Vibration
to 10Hz: 0.25 mm
Earthquake resistance
(m/s2)
Shock
Altitude
Notes:
1. Recommended temperature range is 21 to 24°C.
2. On shipping/storage condition, the product should be packed with factory packing.
3. The above specifications of vibration are applied to all three axes.
4. See ASTM D999-01 The Methods for Vibration Testing of Shipping Containers.
5. See ASTM D5277-92 Test Method for Performing Programmed Horizontal Impacts Using an Inclined Impact
Tester.
6. See ASTM D6055-96 Test Methods for Mechanical Handling of Unitized Loads and Large Shipping Cases and
Crates.
7. Time is 5 seconds or less in case of the testing with device resonance point (6 to 7Hz).
8. When flash modules are installed in the system.

Heat output and air flow

The following table lists the heat output and air flow requirements for the P9500 disk array.
Both the control chassis and the disk chassis contain front and rear fans to circulate air through
the chassis from front to back. Air flows in through the front bezel to the rear of the component
26 Installation requirements
provides the environmental specifications and requirements for the P9500
Operating Not Operating
60.8 - 80.9 ºF -18 - 109.4 ºF / (-10 to 43 ºC)
(16 to 32 ºC) -18 - 95 ºF / (-10 to 35 ºC)
2
20 to 80 % 8 to 90 %
78.8 ºF (26ºC) 80.6 ºF (27 ºC)
50 ºF (10 ºC) 50 ºF (10 ºC)
10 to 300 Hz 5 to 10 Hz: 2.5 mm
1
0.49 m/s 10 to 70 Hz: 4.9 m/s
70 to 99 Hz: 0.05 mm
99 to 300 Hz: 9.8 m/s
7
Up to 2.5 -
- 78.4 m/s
-60 to 3,000m
In Storage
-45 - 140ºF
8
(-25 to 60 ºC)
2
5 to 95 %
84.2 ºF (29 ºC)
68 ºF (20 ºC)
Sine Vibration:
1
4.9 m/s
At the resonant frequency with
the highest displacement found
1
between 3 to 100 Hz
Random Vibration:
0.147 m2/s3
30 min, 5 to 100 Hz
-
1
, 15 ms Horizontal:
Incline Impact 1.22 m/s
Vertical:
Rotational Edge 0.15 m
-
2
1
, 5 min.
3
4
5
6