WARRANTY INFORMATION We Need To Hear From You! To Establish Your Warranty Period And Provide Access To Technical Support, Send Us Your Product Registration Card Today!
This section provides information on the instal- lation and operation of the printer. The printer is a low cost, desktop thermal bar code printer. The PTR2E is a thermal transfer printer specifically designed for printing labels or continuous tape (with or without bar codes) from a Windows™or ASCII-based compatible...
Installation and Operation Unpacking Your Printer PTR2E-MAN Rev.A...
Page 9
Installation and Operation Getting To Know Your Printer PTR2E-MAN Rev.A...
Page 10
Installation and Operation Installation The following steps will guide you through the installation of the printer and media. Step - Attach Power Power OFF Check Power Module Voltage Plug Into Power Module SHOCK HAZARD WARNING See page iv PTR2E-MAN Rev.A...
Page 11
Step - Attach Interface Cable Parallel Interface Serial Interface PTR2E-MAN Rev.A Installation and Operation...
Page 12
Installation and Operation Step - Load Media Open Cover Open Print Head Open Guides Open Guides PTR2E-MAN Rev.A...
Page 13
Step - Load Media (cont.) Media Install Roll PTR2E-MAN Rev. A Installation and Operation...
Page 14
Installation and Operation Step - Load Media (cont.) Thread the Media Seat Media Roll PTR2E-MAN Rev.A...
Page 15
Installation and Operation Step - Load Media (cont.) Close Guides PTR2E-MAN Rev.A...
Page 16
Installation and Operation Step - Load Media (cont.) Close Cover PTR2E-MAN Rev. A...
Page 17
Step - Load Media (cont.) Power ON If the indicator fails to light, refer to Appendix A - Trouble Shooting. Press FEED Button Run the AutoSense routine. PTR2E-MAN Rev. A Installation and Operation...
2 UKQ1813 4.00 Serial port : 96,N,8,1 Press FEED Button Image buffer size:245K Fmem:000,0K,019.9K avl Gmem:000K,0241K avl mem:000K,0241K avl I8,0,001 rY S8 D12 R032,000 ZT UN q0450 Q0800,034 Option:D 11 12 13 now in DUMP HOLD RELEASE Printout PTR2E-MAN Rev.A PRESS...
Page 19
Installation and Operation Feeding External Media Place Media In Rear Note: Media may be placed on PTR2-RS External Roll Stand Face Print Surface UP Insert & Load Media PTR2E-MAN Rev.A...
Page 20
Installation and Operation Thermal Transfer Ribbon Loading Thermal Transfer Print Head Mechanism Ribbon Path PTR2E-MAN Rev.A...
Page 21
Installation and Operation Thermal Transfer Ribbon Loading Open Print Head Load Ribbon Core Load Transfer Ribbon Start Ribbon Open Print Head (Rear View) Pull Ribbon Around Print Head Close PTR2E-MAN Rev.A...
3. Possible label jam. RED. 4. Insufficient memory for label size. 5. Possible software problem. If you are unable to correct the problem, contact Panduit Technical Service at 888-506-5400, ext. 7470. Solution or Reason ware, install directly from program. Oth- erwise, download driver from Panduit web site at www.panduit.com.
Page 23
Printer Maintenance Clean the Print Head Don’t Clean Rollers with Cleaning Pen PTR2E-MAN Rev.A...
Serial Interface The figure below displays the cable wiring required to use the printer's RS-232 serial Cable Wiring interface. Host Cable P/N 300017-006 (6') or 300017-010 (10') Host *+5 volts at 150 mA for external device (e.g. KDU or scanner)