© Panduit Corp. 2004
1
Remove 3" (76.2mm) of cable jacket and untwist pairs.
3
Cut conductors on an angle and insert into cap.
5
Trim conductors flush with cap using wire snipping tool (CWST).
NOTE: Cable jacket is inside the cover.
7A
Apply pressure to cap until it clicks again. Cap must be flush on
housing.
1
Push forward and down against latch at end of guide ramp until
cap releases.
*** FOR USE IN KEYSTONE STYLE OUTLETS AND PATCH PANELS ONLY ***
For Technical Support: www.panduit.com/resources/install_maintain.asp
Keystone Style Jack Modules
INSTALLATION INSTRUCTIONS
Termination Cap Removal Instructions
Page 1 of 2
Part Numbers: KJA588**, KJ66**
PN60B
2
Straighten conductors and arrange in proper color sequence.
4
Pull conductors until outer jacket is inside cap. Bend up 90°.
6
Snap cap squarely on housing until it clicks.
7B
Use Snap Tool (7A) or standard Slip Lock Pliers (7B).
2
Slide screwdriver under cap to separate from housing.