Schematic Diagrams; Schematic Diagram & Circuit Board Layout; Notes - Panasonic VDR-D100EB Service Manual

3 Schematic Diagrams

3.1. SCHEMATIC DIAGRAM & CIRCUIT BOARD LAYOUT NOTES
1. Important safety notice
Components identified by the sign have special
characteristics important for safety. When replacing any
of these components, use only the specified parts.
2. Do not use the part numbers shown on these drawings for
ordering.
The correct part number and part value is shown in the
parts list, and may be slightly different or amended since
this drawing was prepared.
3. Use only original replacement parts:
To maintain original function and reliability of repaired
units, use only original replacement parts which are listed
with their part numbers in the parts list section of the
service manual.
4. Parts different in shape or size may be used.
However, only interchangeable parts will be supplied as
service replacement parts.
5. Test point information
: Test point with no test pin.
Schematic Diagram Notes
1. Indication for Zener Voltage of Zener Diodes
The Zener Voltages of Zener Diodes are indicated as
such on Schematic Diagrams.
Example:
(6.2V)......Zener Voltage
2. How to identify Connectors
Each connector is labeled with a Connector No. and Pin
No. Indicating what it is connected to (its counter part).
Use the interconnection schematic diagram to find the
connection between associated connectors.
Example:
The connections between two P.C.B.s are shown
below.
Ref. No. of the connection parts such as lead cable,
flexible cable which is supplied as a replacement parts.
The Number of pins of the Connector.
POWER SUPPLY
P.C.B.
MAIN P.C.B.
P1503 P3004
244
(10 Pins)
Connector No.
on Main P.C.B.
SCHEMATIC DIAGRAM & CIRCUIT BOARD LAYOUT NOTES
VDR-D100EG/VDR-D100EB/VDR-D150E/VDR-D150EB/VDR-D150EF
/VDR-D150EG/VDR-D150EP/VDR-D150EE/VDR-D150GC/VDR-D150GN
3. Parts marked "PT" are not used in any models included
in this service model.
C6011 C6011
R6097
100P PT
Example: PT
PT
Signal Waveform Note
How to read Signal Waveform
1 Volts/Div
3 V1 1.0 Vp-p
2 Time/Div
3 V1:Peak to Peak
0.5 V 20 µs
1
2
Voltage Chart Note
Voltage Measurement
a. Color bar signal in SP mode.
b. ---:Unmeasurable or not necessary to measure.
Circuit Board Layout Note
Circuit Board Layouts show components installed for
various models.
For proper parts content for the model you are servicing,
please refer to the schematic diagram and parts list.
NOTE:
Circuit Board Layouts include components which are not used.
Model Number Indication
Model numbers are indicated without "VDR-D."
/VDR-D150GCS/VDR-D150SG/VDR-D152EG/VDR-D158GK
9