Samsung SCX-6545N Service Manual page 184

• User Behavior
- User can select one item in the list to reset the counter using "Reset" button or to edit the Max.Life and
threshold value using "Edit" button.
• Items in this column are:
DADF Roller / Rubber Pad Life Page
T1/T2/T3 P-up Roller Life Page
Retard Roller Life Page
Bypass Rubber Pad Life page
Transfer Roller Life Page
Fuser Roller / Fuser Unit Life Page
Heat Roller Life Page
Pressure Roller Life Page
• Status
- The possible values in this column are 'OK', 'Check', 'Negative' and 'Off'.
- OK : Actual counter is smaller than the threshold value
- Check : Actual counter is bigger than threshold value but smaller than Max.Life
- Off : Actual counter exceeds Max.Life
- Negative : There is no counter to display. In this case, it shall display '-' in the
Status and Max Life column.
• Actual
- Values in this column are actual counts for HFSI usage
• Max. Life
Values in this column are maximum life limits set for HFSI.
• Reset
This button is used to reset the actual counter after replacing the HFSI unit.
This button is disabled before user select one item in the list and enabled once user select any of the items
in the list.
Once user presses, a confirmation window shall display to user confirm again. The window is displayed as
below.
If user confirms reset, it will reset the counter to 0.
If the counter of selected item is 0, 'Reset' button shall be disabled.
Service Manual
Alignment & Troubleshooting
4-60
Samsung Electronics