Setup (Initial Settings) - Panasonic VQT9958 Operating Instructions Manual

CONTENTS
Setup
(initial settings)
This VTR's main settings are performed while making
selections using a system of menus.
If a TV monitor has been connected to the VIDEO
OUT 3 connector or SDI OUT 3 connector on the rear
panel, the setting menus are displayed on the TV
monitor.
ON POWER DVCPRO 50
DVCPRO
DV
OFF
METER COUNTER
FULL/FINE
RESET
L
MONITOR SELECT
R
A IN
PREVIEW/PREVIEW AUTO EDIT PREROLL
MONITOR MIX INPUT SELECT
HEADPHONES
VIDEO AUDIO
CH1 CH2 CH3 CH4 TC
PRESET MENU
UNITY
REC LEVEL
PB LEVEL VAR
1
Changing the settings
1
Press the MENU button.
The setup menu screen appears on the TV
monitor, and the setup menu item number appears
on the counter display.
Each time the FF button is pressed, the item
number and item name are selected and displayed
alternately.
(If a setup was performed previously, the screen
on which the last change was made is displayed.)
2
Turn the search dial to select the item to be set.
The menu screen cursor (2) moves, and the item
number on the display flashes.
O When the dial is turned clockwise, the item
number is incremented from 001 5 002 5 003
5 004 and so on; conversely, when it is turned
counterclockwise,
decremented.
O When the FF button or REW button is pressed
while holding down the PLAY button, the next or
previous item is selected.
O Whenever possible, limit the use of the search
dial to the JOG mode.
3
At the position where the change is to be made,
turn the search dial while holding down the search
button.
The settings on the menu screen and display now
flash.
When the dial is turned clockwise, the setting
number is incremented; conversely, when it is
turned counterclockwise, it is decremented.
4 3
JOG SHTL SLOW
ASSEM VIDEO CUE TC STAND BY PLAYER RECORDER
CH1 CH2 CH3 CH4
EDIT PLAY REC
INSERT
A OUT
TRIM
REW STOP FF
SET
IN OUT
SUPER REC INH INT TCG MODE CONTROL
SET DIAG REGEN
ON ON TAPE REMOTE
PRESET
OFF OFF EXIT EE LOCAL
FF button
6 2
the item number
4
Upon completion of the setting, release the search
button.
The item number now flashes.
O When the search dial is in the SHTL mode, the
item will move unless the dial is set to the centre
position.
5
When other items are to be changed, repeat steps
2 4
to .
6
Press the SET button.
The changes are stored in the memory.
To disregard the new settings and restore the
old settings instead, press the MENU button.
O To return the setup contents to the factory
settings (initial settings), press the RESET
button while the menu is displayed.
following message is displayed.
S E T U P - M E N U I N I T S E T
Y E S < P L A Y > / N O < S T O P >
If the PLAY button is now pressed, the factory
settings are reinstated.
<Notes>
O If the RESET button is pressed to restore the
factory settings, only the user files currently in
use are restored. The other user files remain
unaffected.
O The changes made to the SYSTEM menu
contents are recorded also by pressing the
MENU button to close the menu screen.
is
29 (E)
The