Kubota L3200 Operator's Manual page 27

6. Insert the key into the key switch and
turn it "ON".
"PREHEAT"
"ON"
C Check Warning lamps:
When the key is turned "ON", lamps (1) (2) should come
on. If trouble should occur at any location while the engine
is running, the warning lamp corresponding to that
location comes on.
(1) Engine oil pressure
(2) Electrical charge
A Daily checks with the warning lamps only are not
sufficient. Never fail to conduct physical daily checks
carefully by referring to Daily Check section.
(See "DAILY CHECK" in "PERIODIC SERVICE"
section.)
"OFF"
"START"
(3) Glow plug indicator
OPERATING THE ENGINE
7. Fully depress the clutch pedal, turn the
key to "PREHEAT" position and hold it
for the preheating.
For the appropriate preheating time, refer to the table
below:
Temperature
Over 0
0 to -5
-5 to -15
A Glow plug indicator (3) comes on while engine is being
preheated.
8. Turn the key to "START" position and
release when the engine starts.
A Because of the safety devices, the engine will not start
except when the PTO gear shift lever is in the "OFF"
position and the range gear shift lever is in the
"NEUTRAL" position.
9. Check to see that engine oil pressure
and electrical charge lamps are "OFF".
If the lamp is still on, immediately stop the engine and
determine the cause.
10. Release the clutch pedal.
C Cold Weather Starting
When the ambient temperature is below -5
engine is very cold. (If the engine fails to start after 10
seconds, turn off the key for 30 seconds. Then repeat
steps 7 and 8. To protect the battery and the starter, make
sure that the starter is not continuously turned for more
than 10 seconds.)
11
Preheating Time
2 to 3 sec.
5 sec.
10 sec.
and the