MX-J570V/MX-J680V
Removing the drive motor assembly
Prior to performing the following procedure, remove
the metal cover, CD changer mechanism assembly,
the front panel assembly, the microphone terminal
board assembly, the rolling panel assembly and the
main board.
1.
Remove the relay board / fixing board (Refer to
Fig.20).
2.
Remove the two screws K attaching the motor
bracket and remove the motor lead staple n.
3.
Remove the two screws L attaching the shaft
bracket.
4.
Remove the motor belt.
5.
Remove the three screws M attaching the side
bracket.
6.
Remove the shaft assembly from the rolling panel
assembly by lift up the shaft assembly upward.
7.
Remove the drive motor upward.
1-18
(See Fig.38 to 40)
Side bracket
M
Fig.40
W
CN900
CN901
Groove g
Relay board
Fig.20
W
Relay board
Fig.38
L
Shaft bracket
Motor lead staple n
Fig.39
Shaft assembly
Fig.39
Rolling panel assembly
X
Fixing board
Groove h
X
Fixing board
K
Motor bracket
Motor belt
Drive motor