JVC MX-J570V Service Manual page 10

MX-J570V/MX-J680V
Removing the main board
Prior to performing the following procedure, remove
the front panel assembly, the microphone terminal
board and the rolling panel assembly.
1. Disconnect the harness from connector CN867 on
the main board.
2. Disconnect the card wire from connector CN879 on
the main board (Before pulling out the card wire,
stand the part d of CN879 as shown in Fig.15).
3. Remove the two screws N attaching the main board.
Removing the
assembly (See Fig.16)
Prior to performing the following procedure, remove
the front panel assembly.
1. Disconnect the card wire from connector CN306 on
the cassette mechanism board.
2. Remove the eight screws O and P attaching the
cassette mechanism assembly.
3. Pull out the cassette mechanism assembly toward
you.
1-10
(See Fig.14 and 15)
cassette mechanism
CN867
N
CN879
Rolling panel
assembly
Fig.14
Fig.15
O
P
P
CN306
Fig.16
Main board
N
d
CN879
O
P
P
Cassette mechanism board