Connecting 24 Vdc Power To Robot; Specifications For 24 Vdc Power - adept technology Adept Cobra i600 User Manual

3.6

Connecting 24 VDC Power to Robot

Specifications for 24 VDC Power

Table 3-1. Specifications for 24 VDC User-Supplied Power Supply
Customer-Supplied Power Supply
Circuit Protection
Power Cabling
Shield Termination
a
User-supplied 24 V power supply must incorporate overload protection to limit peak
power to less than 300 W, or 8 A in-line fuse protection must be added to the 24 V
power source. (In case of multiple robots on a common 24 V supply, each robot must
be fused individually.)
The power requirements for the user-supplied power supply will vary depending on the
configuration of the robot and connected devices. Adept recommends a 24 V, 6 A power
supply to allow for startup current draw and load from connected user devices, such as
solenoids and digital I/O loads. If multiple robots are to be sourced from a common 24 V
power supply, increase the supply capacity by 3 A for each additional robot.
Vendor Name
XP Power
AstroDyne
Mean Well
Adept Cobra i600/i800 Robot User's Guide, Rev G
a
NOTE: Fuse information is located on the AIB electronics
CAUTION: Make sure you select a 24 VDC power supply
that meets the specifications in
under-rated supply can cause system problems and
prevent your equipment from operating correctly. See
Table 3-2 for recommended power supplies.
Table 3-2. Recommended 24 VDC Power Supplies
Model
JMP160PS24
SP-150-24
SP-150-24
Connecting 24 VDC Power to Robot
24 VDC (± 10%), 150 W (6 A)
(21.6 V< V < 26.4 V)
in
Output must be less than 300 W peak
or
8 Amp in-line fuse
1.5 – 1.85 mm² (16-14 AWG)
Braided shield connects to ground
terminal at both ends of cable. See
3-7 on page 31 and Figure 2-3 on page
22.
3-1. Using an
Table
Ratings
24 VDC, 6.7 A, 160 W
24 VDC, 6.3 A, 150 W
24 VDC, 6.3 A, 150 W
Figure
29