GE B30 UR Series Instruction Manual page 177

5 SETTINGS
The report control configuration settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
CONFIGURABLE REPORT 1
 REPORT 1
 DATASET ITEMS
MESSAGE
MESSAGE
MESSAGE
To create the dataset for logical node LN, program the
attributes supported by the B30. Changes to the dataset will only take effect when the B30 is restarted. It is recommended
to use reporting service from logical node LLN0 if a user needs some (but not all) data from already existing GGIO1,
GGIO4, and MMXU4 points and their quantity is not greater than 64 minus the number items in this dataset.
GE Multilin
 
COMMUNICATIONS
REPORT 1 DATASET ITEMS
ITEM 1:
ITEM 2:
ITEM 3:
↓
ITEM 64:
ITEM 1
B30 Bus Differential System

IEC 61850 PROTOCOL REPORT CONTROL CONFIGURATION
Range: all valid MMS data item references
Range: as shown above
Range: as shown above
Range: as shown above
to settings to a value from the list of IEC 61850 data
ITEM 64
5.2 PRODUCT SETUP
5
5-51