Table of Contents
Advertisement
G-SPEED eS PRO INSTALLATION GUIDE
GUIDE
3. The main screen of the web GUI will appear as shown below. Note
GUIDE Guide
that the G-SPEED eS PRO is set up as a RAID 0. Each of the four
drives in the unit are displayed in the lower Section of the GUI.
NOTE: Please refer to APPENDIX A for detailed information on the features of
the G-Tech RAID Controller web GUI.
10. CHANGING THE G-TECH RAID CONTOLLER MODE
The G-SPEED eS PRO/G-Tech RAID controller combination is
configured at the factory in RAID 0 mode. RAID 1, 3, 5, 6 and JBOD
modes are also available. The web GUI is used to change the mode of
operation. Follow the directions below to change modes.
10.1 Changing from RAID 0 to RAID 5
1.
Unmount G-SPEED eS PRO by dragging the icon to the trash.
2.
Launch the G-Tech RAID Controller web GUI.
3.
Click on the "Maintenance" Link. The window shown below
will appear.
Page 9
Advertisement
Table of Contents
