Garland scar 102 e Instruction Manual page 24

English
Do not run with the scarifier. Walk at the correct
speed that will allow the machine to do its job.
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Look after the machine. Check that all moving parts
are well aligned and that they are not blocked, that
there are no broken pieces or other conditions that
could affect the proper functioning of the machine.
If this machine is damaged, always repair it before
using it again. Most accidents occur because of poor
maintenance.
Maintain the cutting elements sharp and clean. The
cutting elements if sharp and clean will cut better, do
a better job, have less chance of getting tangled and
easier to control.
Turn off and disconnect the machine from the
mains before carrying out any maintenance work
such as adjustments, cleaning, transportation (even
if you are just moving the machine from one working
area to another however close by this might be),
elevating the machine, maintenance or storage of the
machine. These simple security measures reduce the
risk of accidental start up.
Do not incline the machine with the engine running.
2.6. MAINTENANCE
Take your machine for periodic revision to a
qualified after sales dealer and only use original
spare parts and accessories. This will guarantee that
the security measures of this electris machine can
always be complied with.
24/112