Boot Sequence - Dell Inspirion 530 SERIES Owner's Manual

SATA Mode
Power Management Setup
ACPI Suspend Type S1(POS); S3(STR) (S3(STR) by default)
Remote Wake Up
Auto Power On
Auto Power On
Date
Auto Power On
Time
AC Recovery

Boot Sequence

This feature allows you to change the boot sequence for devices.
Option Settings
•
•
•
•
Downloaded from www.Manualslib.com
IDE; RAID (IDE by default)
NOTE:
On; Off (On by default)
Enabled; Disabled (Disabled by default)
0
0:00:00
Off; On; Last (Off by default)
Diskette Drive — The computer attempts to boot from the floppy drive.
If the floppy disk in the drive is not bootable, if no floppy disk is in the
drive, or if there is no floppy drive installed in the computer, the computer
generates an error message.
Hard Drive — The computer attempts to boot from the primary hard
drive. If no operating system is on the drive, the computer generates an
error message.
CD Drive — The computer attempts to boot from the CD drive.
If no CD is in the drive, or if the CD has no operating system, the
computer generates an error message.
USB Flash Device — Insert the memory device into a USB port and
restart the computer. When F12 = Boot Menu appears in the upper-
right corner of the screen, press <F12>. The BIOS detects the device and
adds the USB flash option to the boot menu.
NOTE:
To boot to a USB device, the device must be bootable. To make sure that
your device is bootable, check the device documentation.
manuals search engine
Applicable for Inspiron 530, 530a and 530c only.
191
Appendix