Locked Condition; Installation Instructions - Bosch Therm 8000 S GWHC 27 CTDE Installation And Operating Instructions Manual

14 | Installation instructions

Fig. 18 Error code
After following instructions in dicated in "Troubleshooting"
section,
B press reset button rmly in order
operation.
Fig. 19 Reset button
If the problem persists, contact your installer.
6 720 680 174 (2012/09)

4.12 Locked condition

This condition is only valid fo
remote controls installed.
Fig. 20 Locked condition
to return heater to normal
Whenever LCD shows
be adjusted because the appliance is in use by a user which
already selected a di erent temperature. Appliance will be
automatically unlock 5 minutes after closing hot water tap.
5
r appliances with one or more
the temperature setting cannot
Installation instructions
DANGER: Explosion
B Always close the gas valve before doing
any work in gas components.
The installation, the el ectric connection, the
gas installation, the installation of the
exhaustion / admission conducts, as well as
the start up must be carried out by a quali ed
technician.
The appliance can only be used in the
countries mencioned in the type plate.
CAUTION:
B Do not install the appliance where the
inlet water temperature is superior to
60°C. In such cases we recommended the
installation of a mixer's valve in the
entrance of the appliance as prevention
measure.
6720608920-33.1AL
Therm 8000 S