Removing And Installing The Door Panels; Troubleshooting; Malfunction Table; Replacing The Bulb In The Oven Ceiling Light - Siemens HP243527M Instruction Manual

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
$
Fold back both locking levers (figure C). Close the oven
3.
door.
&
ã=
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Problem Possible cause Remedy/information
The oven does The circuit
not work. breaker is
defective.
Power cut
The clock dis- Power cut
play flashes.
The oven does There is dust on
not heat up. the contacts.
The gas burner Power failure or
does not ignite. damp ignition
plugs.
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Light the gas burner with a
gas lighter or a match.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Detach the oven door and lay on a cloth with the handle
1.
facing down.
Unscrew the cover on top of the oven door. To do this, undo
2.
the left and right screws (figure A).
Lift the panel, and pull it up and out (figure B).
3.
$
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper.
The glass could be damaged.
Insert the panel diagonally towards the back. The smooth
4.
surface must face outwards.
Put the cover back in place and screw it on.
5.
Attach the oven door.
6.
Do not use the oven again until the panels have been
correctly fitted.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent damage.
1.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.

Glass cover

You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
%
15