Special Function 1 Increasing The Final Rinse Temperature - Miele PG 8052 Operating Instructions Manual

Programming special functions
Special function 1
Increasing the final rinse
temperature
If you alter the final rinse temperatu-
re, make a note of the new tempera-
ture in the appropriate column of the
Programme chart.
The final rinse temperature factory set-
ting is listed in the programme chart. It
can be changed as follows:
– from 65 °C to 85 °C (G 8050/G 8051)
– from 65 °C to 75 °C (PG 8052).
If the final rinse temperature has
been programmed to 85 °C or
75 °C, the drying fan will switch on
at a certain temperature to compen-
sate for any build-up of steam.
The drying fan will continue to run
for 45 minutes after the programme
has finished.
We recommend programming a final
rinse temperature of 65 °C for cleaning
dirty crockery.
The final rinse temperature cannot be
altered in the o (GLASSWARE) or the ,
(BEER GLASSES) programme.
42
It is not possible to alter the final rin-
se temperature while a programme
is running. You will have to cancel
the programme first. The h/f indi-
cator light must be flashing.
^ Switch the dishwasher off with the
On/Off button I-0.
^ Press the +c and h/f buttons and
whilst holding them in switch the
dishwasher on with the On/Off button
I-0.
Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on.
The "Salt" k indicator light will flash.
The set water hardness will then appear
in the Time left display.
^ Press the +c button twice.
The 1 indicator light will come on to
show that you are in programming le-
vel.
The y indicator light will come on or
will flash to show that you are in Special
function 1.
The k indicator light will flash.