Venting The Dispensing System - Miele PG 8052 Operating Instructions Manual

Having changed a value or all values:
^ Press the Start/Stop button h/f twi-
ce.
The indicator light beside the h/f but-
ton will flash.
The programmed dispensing time is
now stored in memory.
^ Switch the dishwasher off with the
On/Off button I-0.
Value set:

Venting the dispensing system:

It is not possible to vent the system
while a programme is running. You
will have to cancel the programme.
The h/f indicator light must be
flashing.
^ Set the dosage selector on the DOS
module to position 10 (applies to
DOS Module C 60 only).
^ Switch the dishwasher off with the
On/Off button I-0.
^ Press the +c and h/f buttons in
and whilst holding them in switch
the dishwasher on with the On/Off
button I-0.
^ Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on.
The "Salt" k indicator light will flash.
The set water hardness will then appear
in the display.
Programming special functions
^ Press the +c button once.
The set dispensing time will appear in
the display, e.g. 10 (factory setting).
The c indicator light will come on.
(This indicates the programming level.)
The k indicator light will flash.
^ Press the d button once.
"do1" will appear in the display.
^ Press the d button again.
The venting process will be carried out.
The time remaining will appear in the
display.
At the end of the time 0 will appear in
the display.
The dispensing system has now been
vented.
^ Switch the machine off with the I-0
button.
Immediately after this: start the I
COLD programme so that after venting,
any agents in the wash cabinet are dilu-
ted before being drained away.
41