Programming Special Functions; Dispensing System Settings For Dos Module G 60 Or C 60 (Optional Extras); Setting The Dosage - Miele PG 8052 Operating Instructions Manual

Programming special functions

Dispensing system settings for
DOS Module G 60 or C 60
(optional extras)
For future servicing work, please do-
cument any alterations to the stan-
dard factory settings. Enter any alte-
rations in the relevant
Value set:

Setting the dosage:

It is not possible to set the dosage
while a programme is running. You
will have to cancel the programme.
The h/f indicator light must be
flashing.
^ Set the dosage selector on the DOS
module to position 10 (applies to
DOS Module C 60 only).
^ Switch the dishwasher off with the
On/Off button I-0.
^ Press the +c and h/f buttons
and whilst holding them in switch
the dishwasher on with the On/Off
button I-0.
^ Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on.
The "Salt" k indicator light will flash.
If this does not happen, start the proce-
dure from the beginning again.
The set water hardness will then appear
in the display.
40
box.
^ Press the +c button once.
The set dispensing time will appear in
the display, e.g. 10 (factory setting).
The c indicator light will come on.
(This shows the programming level)
The k indicator light will flash.
The programming level for the DOS mo-
dule has now been called up.
Set the dosage according to the ma-
nufacturer's recommendations.
The machine needs 5.4 litres of water in
the main wash stage of the programme
if there is no increasing of the water le-
vel programmed.
Example:
A manufacturer recommends 4 ml clea-
ning agent per litre of water:
5.4 l x 4 ml/l = 21.6 ml.
2 ml . 1 second dispensing time; i.e.
programme to 11 seconds.
^ Use the programme selector buttons
%$ to select the value that corre-
sponds to the dispensing time you
want.
Use the % button to scroll down and
select a lower value.
Use the $ button to scroll up and in-
crease the value.
The value set will appear in the display.