Connecting Power Supply - Hitachi CP-WU8460 User Manual

Hide thumbs Also See for CP-WU8460:
Table of Contents

Advertisement

Fastening the adapter cover
sure to connect the adapter to the further USB
TYPE A port from the LAN port and use the
supplied adapter cover.
1.
Loosen the screw (marked with triangle) on
the bottom left of the USB TYPE A ports.
Insert the tab of the cover into the hole at the upper right of
2.
the USB TYPE A ports in the direction of the arrow.
3.
Align the screw holes on the projector and the cover. Then
insert the screw removed from the projector into the hole and
tighten the screw.
WARNING
pets. Take care not to put in the mouth.
possible burns disconnect the projector power cord for 10
minutes before touching the adapter.

Connecting power supply

1.
Put the connector of the power cord into the AC (AC
inlet) of the projector.
2.
couple of seconds after the power supply connection,
the POWER indicator will light up in steady orange.
Please remember that when the DIRECT POWER ON
function activated, the connection of the power supply
make the projector turn on.
WARNING
unit is attached to it.
Please use extra caution when connecting the power cord, as incorrect or
Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
shock or other accidents.
of the building using an appropriate power cord (bundled).
NOTICE
to-phase voltage of 220 to 240 V.
8
1
Power
cord
2
Tab
3
AC

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-wx8265Cp-x8170

Table of Contents