Operating Your Compact 2 - Rinnai Compact 2 Operation Manual

Operating your Compact 2

Your Compact 2 is operated by manual push button control, located on the left
hand side of the appliance.
Ignition
Firmly press the IGN button
for 10 seconds and release.
This operates the built-in
safety device and starts the
electronic spark—lights to
pilot.
If the pilot does not remain
alight, wait two minutes before
retrying to ignite. If the heater
does not ignite on initial use, it
may be due to air remaining in
the gas supply line.
Adjusting the heat
Press the buttons from LOW
to HIGH. This will ignite the
additional burners.
Turning off
Press and release the buttons
from HIGH to IGN until they
are in the off position. The fan
will stop when the heater cools
down.
Fan operation
The fan will operate
automatically when the heater
warms up, and will stop when
it cools. When the heater is on
the LOW setting, the fan may
turn off as the heater cools.
The fan will restart again once
the heater warms up.
In the event of a power
failure
If there is a power failure,
turning the heater to the LOW
setting may allow the heater
to continue operating without
overheating. Remaining on
the HIGH setting will cause the
overheat protection switch to
activate. This will shut down
the appliance.
HIGH LOW
The words HIGH, LOW and IGN are not
part of the control panel. They have been
displayed to highlight what each of the
different settings mean.
IGN
Compact 2 Operation Guide: 11837-C 03-15 | 7