Search Method; Code Blink Out - One for All URC-6231 Instruction Manual

Hide thumbs Also See for URC-6231:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Search Method

If your Television does not respond to the ZAPPER after trying all the codes listed for your
brand, try searching for your code.
Example: to search for your TV code:
1
Make sure your TV is switched on (not on standby).
2
Open the flap to enable access to the MAGIC key.
3
Press the TV key.
4
Press and hold the MAGIC key until the LED blinks twice (The LED
underneath the POWER key will blink once then twice).
5
Next, press the OK (mute), DOWN, DOWN.
6
Point the ZAPPER at your television. Next, alternate between POWER and CHANNEL -
until your Television turns OFF. You may have to press these keys many times (up to 150!),
so please be patient. Remember, you must aim the ZAPPER at your device the entire time
you are searching for your code.
7
When your device turns off, press and release MAGIC to store the code. The ZAPPER
should now be ready to operate your Television. Turn your device back on and try all the
remote's functions to ensure they are working properly. If some of the ZAPPER'S com-
mands are not operating correctly, try the search method again, you may be using the
wrong code.
- To set up your DVD player or Satellite Receiver please press the corresponding
device key during step 3.

Code Blink Out

Example: To blink out your TV code:
1
Open the flap to enable access to the MAGIC key.
2
Press the TV key.
3
Press and hold the MAGIC key until the red LED blinks twice
(the LED underneath the POWER key will blink once then twice).
4
Next, press OK (mute), UP, DOWN.
5
For the first digit of your 5-digit code, press RIGHT and count the red blinks.
6
For the second digit, press LEFT and count the red blinks.
7
For the third digit, press UP and count the red blinks.
8
For the fourth digit, press DOWN and count the red blinks.
9
For the fifth digit, press OK (mute) and count the red blinks.
- To blink out the code you programmed for your DVD player or Satellite Receiver
please press the corresponding device key during step 2.
WWW.ONEFORALL.COM
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Urc-6230

Table of Contents