HP 3PAR StoreServ 7450c Planning Manual page 37

Table 20 SP and Storage System Software Installation Checklist (continued)
Custom duplex (half or full) and
Custom speed (10, 100, or 1000 MB/s)
Proxy server settings for Remote Support (if applicable):
Protocol
Address and port
Authentication information (optional)
Date and time:
Enter manually
Use NTP server information
Time zone region
New password to assign setupusr (for use with the system setup wizards)
NOTE: All passwords for the setupusr username must be between 7 and 32
characters in length and can consist of alphanumeric characters and the following
special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/).
New password to assign 3parcust (to access SPOCC)
NOTE: All passwords for the 3parcust username must be between 7 and 32
characters in length and can consist of alphanumeric characters and the following
special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/).
Serial number
NOTE: The serial number is located on the back of your HP 3PAR storage system
next to the power switch for the node enclosure PCM. It begins with 16 (for example,
1624635).
StoreServ system name
IP address (IPv4 only)
Subnet mask
Gateway IP address
If applicable,
Domain Name
DNS Server
Enable remote support:
Protocol
Address
Port
Customer contact:
Installation site information
Customer information
Date and time:
Copy from SP
Enter manually
Use NTP server information
Time zone region
HP 3PAR Storage System
Storage System Software Installation Checklist 37